|
DSL Setup - Windows Vista |
 |
 |
- Click the Windows Start button
- Click Control Panel.
 - Make sure you are in Classic View. You can do this by clicking Classic View.
*The link for Classic View can be found on the top left hand corner of your your screen.
 - Double click on Network and Sharing Center, listed alphabetically in the list of icons on the right hand side.
 - Click Set up a connection or network on the left hand side under Tasks.
 - Select Connect to the Internet and then click Next.
 - You now have the choice between Broadband (PPPoE) and Dial-up. Click on Broadband (PPPoE).
 - You will now be prompted to enter in the settings to configure your DSL service with Execulink Telecom. This screen will ask you to enter in your Execulink Telecom Username and Password. This will be your full Primary E-mail address. An example of this would be
This e-mail address is being protected from spambots. You need JavaScript enabled to view it
or
This e-mail address is being protected from spambots. You need JavaScript enabled to view it
. Also make sure to check Remember this password.
 - As long as you have your DSL hardware setup properly, the setup will complete and you can click connect.
*If your DSL hardware is not setup properly, it will fail to connect. Click Create this connection anyways.
 RANK THIS PAGE:
|
